- #Bus simulator 18 kneeling manual
- #Bus simulator 18 kneeling code
- #Bus simulator 18 kneeling password
NOTE – The available source addresses will vary depending on each vehicle configuration. Refer to Source Addresses (SA) for more information.įMI=0 – Data Valid But Above Normal Operational Range – Most Severe LevelįMI=1 – Data Valid But Below Normal Operational Range – Most Severe LevelįMI=2 – Data Erratic, Intermittent Or IncorrectįMI=3 – Voltage Above Normal, Or Shorted To High SourceįMI=4 – Voltage Below Normal, Or Shorted To Low SourceįMI=5 – Current Below Normal Or Open CircuitįMI=6 – Current Above Normal Or Grounded CircuitįMI=7 – Mechanical System Not Responding Or Out Of AdjustmentįMI=8 – Abnormal Frequency Or Pulse Width Or PeriodįMI=12 – Bad Intelligent Device Or ComponentįMI=15 – Data Valid But Above Normal Operating Range – Least Severe LevelįMI=16 – Data Valid But Above Normal Operating Range – Moderately Severe LevelįMI=17 – Data Valid But Below Normal Operating Range – Least Severe LevelįMI=18 – Data Valid But Below Normal Operating Range – Moderately Severe LevelįMI=31 – Condition Exists SOURCE ADDRESSES (SA) This number identif es the module reporting the fault. This number represents the number of times a fault has gone from previously active to active.
#Bus simulator 18 kneeling manual
Refer to the Vehicle Information Display Owner’s Manual for more information.
#Bus simulator 18 kneeling password
The VID may initiate a password prompt if the VID has been password protected. NOTE – The following selections will not be available if the vehicle is not equipped with the option to display codes.ģ. Perform the following steps if all of the above conditions are met: The feature is not password protected to prevent unauthorized access.
Displaying Codes on the VID (if equipped) NOTE – Turning the key switch off, turning the key switch to the CRANK position, or releasing the park brake will take the gauge cluster out of the diagnostic mode. The following information will be displayed for each fault: To manually cycle through the fault list press and release the cluster display selector button. Once all faults have been displayed the number of faults will be displayed again, then the cycle will repeat.
#Bus simulator 18 kneeling code
If faults are present, the gauge cluster display will show each diagnostic trouble code for 10 seconds and then automatically scroll to the next entry and continue to cycle through the faults. NOTE – The gauge cluster will only display “Software Rev” and “Hardware Rev” for 5 seconds followed by the message “Diagnostic Trouble Codes are not available” if the vehicle is not equipped with the option to display codes. The gauge cluster will then display the following information for 5 seconds: